01 Pot Lights
A pot light installation sits flush with the ceiling. The spacing is worked out before the first hole is cut.
The Wire Guys install the fixed electrical parts of a home across British Columbia — pot lights, bathroom fans, GFCI outlets, ceiling fans, breakers and baseboard heaters, from the Fraser Valley to Vancouver and Victoria. Every job is signed off before we leave.
4.7 stars from 137 Google reviews Read them on Google
Licensed Electrical Contractor
Licensed and insured in British Columbia.
WorkSafeBC Registered
Active and in good standing.
BBB Accredited
Accredited since 2023.
Canadian family owned, working across British Columbia since 2019.
Get a quoteStraight answer
An electrical installation job adds or replaces a fixed part of a home's wiring, such as a light, outlet, fan, breaker or heater, rather than tracing an existing fault. Home electrical installation runs from one GFCI outlet to a room of pot lights. We provide electrical installation services across British Columbia.
The Wire Guys Electrical Ltd. is a licensed electrical contractor serving Abbotsford, Vancouver, Victoria and communities across the Lower Mainland, Fraser Valley and Greater Victoria, handling residential and commercial electrical work for homeowners, landlords and business owners in British Columbia.
The list
These are the installations homeowners ask about most. For switches and breakers, brands we install include Leviton, Lutron, Schneider and Square D.
01 A pot light installation sits flush with the ceiling. The spacing is worked out before the first hole is cut.
02 A bathroom exhaust fan installation moves shower moisture outside before it damages paint and drywall. It only works if the duct vents outdoors.
03 A smoke alarm warns of fire, and a carbon monoxide alarm warns of a gas you cannot see or smell. Placement is covered under smoke and CO detector installation.
04 A GFCI outlet installation cuts power in a fraction of a second when current leaks to ground, so it belongs near water. We install GFCI and AFCI protection wherever the code requires it.
05 A ceiling fan installation needs a box rated for the fan's weight and movement. The box behind an old light fixture often is not.
06 We find out why a breaker trips before any circuit breaker replacement. That check is $165 for a 45-minute diagnostic.
07 Most baseboard heater installation jobs need a 240-volt circuit sized to the heater. A thermostat on the wall controls it.
A single job or a short list is booked and signed off like a larger job.
A deck outlet, a new switch and a ceiling fan are all new installations we book on their own. Anyone looking for electrical installation near me in the Fraser Valley, Vancouver or Victoria can book one with us.
Before you say yes
Installation work with The Wire Guys costs $135 an hour for a Red Seal electrician plus a helper, the same rate at 3am as at 3pm, and many jobs have a flat rate. Work we can see gets a free electrical estimate. Tracing a fault is $165 for a 45-minute diagnostic, which tells you what the problem is and how we are going to fix it.
Electrician installation cost depends on:
We pull the permit before work starts. Abbotsford, Chilliwack, Mission and Langley permits come from Technical Safety BC; Vancouver, Victoria, Surrey and Burnaby run their own offices. See the permit steps on a panel upgrade.
We are there for the inspection on jobs such as a new hot tub circuit. If an inspection does not pass on our work, we put it right, call the inspector back, and we cover the cost.
If something we installed is not right, we come back. Anything that cannot wait goes to our 24-hour emergency electrician.
There is no set price for adding an outlet. It depends on whether a circuit with room is nearby, how far the wire runs, and whether GFCI protection is needed. Whether a job needs a permit depends on the work, and adding a new outlet or circuit does.
Both, depending on the job. We charge $135 an hour for a Red Seal electrician plus a helper, the same rate at 3am as at 3pm. Many predictable jobs get a flat rate, so the number is agreed before work begins.
One outlet on its own is enough for us to book the job. A single-item job is priced the same way as a larger one: the time it takes at our hourly rate, or a flat rate where the job suits one.
Some electricians do. For installation work we can see, the estimate is free and the electrical installation quote comes in writing before we start, so you see the price first. Tracing a fault is different: that is $165 for a 45-minute diagnostic.
It can happen when the scope changes after the quote: more labour, something found behind a wall, or costlier fittings. A quote is priced on what we can see — if the scope changes we tell you before we do it, not after.
Call 778-708-0451. We are open 24 hours.